Date of Issue: 11-18-2002

CCNA IP Routing Lab Scenario

This Lab Scenario will familiarize you with basic IP routing configurations. It starts by having you enable and disable use of the all-zeroes subnets. Then you configure RIPv1, RIPv2, and EIGRP. Finally, you look at some of the pitfalls that can be encountered when using these routing protocols.

Introduction
  Goals
  Equipment
  Initial Configuration
Tasks
  Task 1: Configure ip subnet-zero
  Task 2: Assign IP Addresses and Enable RIPv1 on All Routers
  Task 3: RIPv2 Configuration and Disabling Automatic Summarization
  Task 4: Configure Basic EIGRP
  Task 5: Disable EIGRP Automatic Summarization
Solutions
  Task 1
    R1 Configuration
  Task 2
    R1 Configuration
    R1 Route Table
    R2 Configuration
    R2 Route Table
    R3 Configuration
    R3 Route Table
  Task 3
    R1 Configuration
    R1 Route Table
    R2 Configuration
    R2 Route Table
    R3 Configuration
    R3 Route Table
  Task 4
    R1 Configuration
    R1 Route Table
    R2 Configuration
    R2 Route Table
  Task 5
    R1 Configuration
    R1 Route Table
    R2 Configuration
    R2 Route Table